- Three-wire link between cell and MR2 – two wires for the battery current, one for the temperature sensor
- JST-PH 2.0 socket on the board side, bare, stripped and tinned wire ends on the cell side
- 20 cm long – enough slack for routing inside the enclosure
- Also available pre-assembled with protection module and temperature sensor
Description
Battery connection cable for the Inhero MR2 – a three-wire link between cell and board. Two wires carry the battery current; the third carries the battery temperature sensor, which the MR2 evaluates for temperature-controlled charging.
Technical specifications
- Connector: JST-PH 2.0, 3-pin, socket (2.0 mm pitch)
- Length: 20 cm
- Wire ends: bare, stripped and tinned
- Pinout: battery plus, battery minus, temperature sensor
- Compatible with: Inhero MR2 (battery input)
What's in the box
- 1× battery connection cable, 20 cm
⚠ Important notes
- The MR2 has no hardware reverse-polarity protection on the battery input. Reversed polarity destroys the board immediately and irreversibly.
- Protection module and temperature sensor are not included. If you would rather avoid soldering at the cell, this cable is also available pre-assembled with a protection module and integrated temperature sensor.
Manufacturer Information (GPSR)
Inhero GmbH, Gewerbestraße 19, 08115 Lichtentanne, Germany · info@inhero.de