Battery Connection Cable for MR-2, JST-PH 2.0 3-pin, 20 cm

• Three-wire link between cell and MR-2 – two wires for the battery current, one for the temperature sensor
• JST-PH 2.0 socket on the board side, bare, stripped and tinned wire ends on the cell side
• 20 cm long – enough slack for routing inside the enclosure
• Also available pre-assembled with protection module and temperature sensor

Description

Battery connection cable for the Inhero MR-2 – a three-wire link between cell and board. Two wires carry the battery current; the third carries the battery temperature sensor, which the MR-2 evaluates for temperature-controlled charging.

Technical specifications

• Connector: JST-PH 2.0, 3-pin, socket (2.0 mm pitch)
• Length: 20 cm
• Wire ends: bare, stripped and tinned
• Pinout: battery plus, battery minus, temperature sensor
• Compatible with: Inhero MR-2 (battery input)

What's in the box

• 1× battery connection cable, 20 cm

⚠ Important notes

• The MR-2 has no hardware reverse-polarity protection on the battery input. Reversed polarity destroys the board immediately and irreversibly.
• Protection module and temperature sensor are not included. If you would rather avoid soldering at the cell, this cable is also available pre-assembled with a protection module and integrated temperature sensor.